Connecting The Accessories - Clarion VX409 Mode D'emploi Et Manuel D'installation

Connecting the parking brake cord
Connect the cord to parking brake lamp ground in the meter panel.
Note:
• Connecting the parking brake cord to lamp ground allows you to watch iPod video/DVD video/AV input
when the parking brake is engaged.
• When the parking brake cord is not connected, the monitor will not show any video sources.
• If "AUDIO ONLY" appears on the screen just after turning on the ACC power of the car, release the parking
brake while confirming safety, and then engage the parking brake again.
Parking brake lamp
+ cord to battery
Electro-tap
Parking brake cord
(Grass-green)

Connecting the Accessories

Connection to the external amplifier
The external amplifiers can be connected to the 6 channel RCA output connections. Ensure that the
connectors are not grounded or shorted to prevent damage to the unit.
Connection to iPod devices
The iPod device can be connected to dedicated iPod connection on the main unit. For detailed
information, refer to the instruction sheet or manual for the iPod cable.
Note:
• This unit may not support all functions of all iPod devices
• The iPod connection will charge your iPod unless the iPod battery is completely depleted.
If the specified cord of the cellular phone is connected to the phone interrupt cord of the main
unit, the audio mute is available when the cellular phone is used.
Sirius Satellite Radio Receiver
When a Sirius Satellite Radio Receiver is to be connected, use the dedicated connector. For detailed
information,refer to the instruction manual of the Sirius Satellite Radio Receiver.
Parking brake
Parking brake
signal cord
How to attach the electro-tap
1. Place the Parking brake cord at the stopper, and
fold it back in the direction of the arrow.
2. Pass the Parking brake signal cord through, and
fold it back in the direction of the arrow.
Parking brake
signal cord
Stopper
Parking brake
signal cord
Parking brake cord
(Grass-green)
47
VX409/VZ409