Clarion VX409 Mode D'emploi Et Manuel D'installation page 42

Installing the Main Unit in a TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked
Center Panel
( * 2 )
Note:
*2: Some panel openings are too small for the unit
depending on the vehicle type and model. In
such a case, trim the upper and lower sides of the
panel frame by about 0.5 to 1.5 mm so the unit
can be inserted smoothly.
E
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)
Removing the Main Unit
When the main unit is to be removed, disassemble it in the reverse of the order in "INSTALLING THE
MAIN UNIT"
42
VX409/VZ409
Figure 7
Typical Mounting Brackets
x a m p e l 1 Example 2
Affix the screws to the
are attached to the vehicle.)
Main Unit
* 3
*3: If a hook on the installation bracket interferes
with the unit, bend and flatten it with a nipper or
similar tool.
marks.
8-Hexagonal screw
(M5 × 8)
Mounting bracket
(1 pair for the left
and right sides)
E x a m p e l 3