Notice D'utilisation - Migatronic PILOT 1500 HP Manuel D'instruction

Utilisation générale
Affichage digital
Le panneau de commande est divisé en trois com-
partiments avec les voyants indiquant le courant de
soudage. En position attente le courant de soudage
réglé est indiqué. Lors de soudage la valeur moyenne
du courant de soudage est affichée.
Disconnection error
A yellow LED indicates that the machine is
overheated due to overloading or because
mains voltage exceeds permissible range (195-
265V). When the situation is back to normal, the
machine will reconnect automatically. Therefore, weld-
ing cables are to be placed so as to avoid the risk of
unintended establishment of the arc when the machine
reconnnects.
Tension de soudage
Le voyant de tension de soudage s'allume si
l'électrode ou la torche est sous tension.
Courant de soudage
Le courant de soudage est réglé par ce
sélecteur. Le courant de soudage est réglable de 15 A
au courant maximal de la machine.
Function switch
This switch is used to choose between MMA or
TIG welding, between two-stroke and four-
stroke in TIG welding, and to choose ignition
method in TIG welding.
This symbol means MMA welding.

NOTICE D'UTILISATION

arc is established in the following way:
1) The torch is placed so that the Tungsten electrode
2) The torch trigger is activated, and the high voltage
The arc is established in the following way:
1) The torch is placed so that the Tungsten electrode
2) The torch trigger is activated, and the high voltage
is established in the following way:
1) The torch is placed so that the Tungsten electrode
2) The torch trigger must be kept pressed down.
24
This symbol means TIG welding.
Two-stroke
This symbol means contact-free striking. The
is quite close to the welding spot (1 or 2 mm).
generator of the machine will produce a voltage
impulse that ignites the arc. The welding process
has started. The welding process will stop when
the torch trigger is deactivated.
Four-stroke
This symbol means contact-free striking.
is quite close to the welding spot (1 or 2 mm).
generator of the machine will produce a voltage
impulse that ignites the arc. The torch trigger is
deactivated. The welding process will stop when
the torch trigger is reactivated. The arc will
extinguish after the period of slope-down time.
Two-stroke
This symbol means LIFTIG ignition. The arc
has contact with the welding spot.