Preparation - Mesto 3232 Mode D'emploi

EN

Preparation

The device must be in an upright position.
into the tank.
1. Pull up the red piston pressure gauge handle [14] until the tank is depressurized.
2. Unscrew the pump [2] from the tank.
+
If used for HERBICIDES, this spraying device should no longer be used for applying
pesticides.
3. Add the spraying liquid to the tank [1]
5. Screw the pump [2] into the tank.
6. Press the piston rod with handle [16] down and turn it counterclockwise.
7. Create the desired pressure
+
8. Press the piston rod with handle [16] down and turn it counterclockwise.
Spraying
Operate the device only while it is vertical or suspended upright and nearly vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Hang the device over your shoulder. (Fig. 11)
+
gauge [14]
Spraying pressure
1.5 bar (21.8 psi)
2.0 bar (29.0 psi)
3.0 bar (43.5 psi)
4. If the spraying pressure decreases more than 0.5 bar
pump some more.
+
.
)
)
in the tank
Spray quantity for hollow cone nozzle
0.48 l/min (0.13 gal/min)
0.56 l/min (0.15 gal/min)
0.69 l/min (0.18 gal/min)
16
ENGLISH
from the optimum level,