Replacement Of Printer Paper - Schiller Argus VCM Mode D'emploi

ARGUS VCM

Replacement of Printer Paper

The monitor provides the indication as follows:
The Manual Print indicator will flash in Manual mode.
The Stream Print indicator will flash in Stream mode.
1. Open the door by pulling the latch on the printer slightly. The door should tilt open.
2. Reach in and remove the spent paper core by pulling it over gently with your thumb
and index finger.
3. Place a new paper roll. Orient the paper roll.
4. Pull the paper towards you until approximately 2 inches (5.08 cm) of paper have been
unrolled.
5. Align the paper with the pinch roller attached to the printer door.
6. Close the printer door.
Note: To ensure that the paper is aligned in the slot and has not been pinched in the door,
pull the loose edge until a few inches of paper is showing. If the paper will not move,
open the door and return to alignment step 5.
Note: The monitor sounds an invalid button tone when the printer door opens or when
paper runs out.
Operator's Manual
ARGUS VCM
Maintenance
81