Measurement Cable Connections - Schiller Argus VCM Mode D'emploi

Setting up the Monitor

Measurement Cable Connections

WARNING: Do not lift the monitor by the sensor cables, or power cord because the
cable could disconnect from the monitor, causing the monitor to drop on the patient.
NIBP Hoses and Cuffs
NIBP Cuff Hose Connector
1. Select the appropriate size cuff for the patient (Refer to the NIBP Monitoring
2. Connect the hose to the right panel NIBP connector (see Figure 4).
Note: For the safety of patients, and to ensure the best product performance and accuracy,
use only a cuff and a hose provided with
by Schiller Technical Services.
SpO2 Cables and Sensors
1. Select an appropriate sensor for the patient and desired application.
2. Apply the sensor to the selected site.
3. Connect the sensor to the cable.
4. Connect the cable to the right panel SpO2 connector (see Figure 5).
Note: For the safety of patients, and to ensure the best product performance and accuracy,
use only Schiller provided sensor pulse oximetry cables and SpO2 sensors with
.
VCM
18
ARGUS VCM
1
Figure 4. NIBP Cable Connections
section) and apply the cuff to the selected site.
Figure 5. SpO2 Sensor/Cable Connections
Operator's Manual
, or a cuff and hose recommended
ARGUS VCM
1
SpO2 Sensor/ Cable Connector
ARGUS VCM
ARGUS