Pressure Testing; Servicing - Falcon 1092 CT Dual Fuel Mode D'emploi

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
The Outer Burners
Screw in the hexagon headed venturis but to make
fitting the other burners easier do not fully tighten yet.
an outer burner
When all the burner bases and venturis have been fitted
tighten the venturi nuts.
Reassemble burner heads, making sure they are
reassembled in the correct way on the burner bodies.
base of cook top burner
Replace the smaller rings on the
outer burners. The very small ring is
for the right hand front burner.
bottom of burner head
SERVICING - WARNING
Refit the pan supports.
Reassemble in reverse order.
Stick on label
Stick the appropriate label on to the data badge to
indicate the gas the appliance is now set for.

Pressure Testing

Connect the appliance to the gas supply.
Check the appliance is gas sound.
The gas pressure can be measured at the pressure test
point on the gas inlet. Turn and light one of the hotplate
burners.
Check operation of all the burners.

Servicing

When servicing or replacing gas carrying components,
disconnect from the gas supply before commencing
operation.
Check the appliance is gas sound after completion of
service. When checking for gas leaks do not use washing
up liquid - this can corrode. Use a product specifically
manufactured for leak detection.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before
commencing servicing, particularly before removing any
of the following: - control panel, side panels, hotplate tray
or any electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
Note - References to LH and RH oven apply as viewed
from the front.
BEFORE SERVICING ANY GAS CARRYING COMPONENTS.
TURN OFF THE GAS SUPPLY.
1 To Remove the Hotplate
Disconnect the appliance from the electricity supply. Pull
the unit forward to gain access.
a) Remove the French cooktop/pan supports/hotplate
accessories and burner caps.
b) Remove the brass venturi in the centre of each hotplate
burner bezel.
c) Remove the bezel from the hotplate and disconnect the
spark ignition lead from the spark electrode.
d) Lift the hotplate clear of the appliance.
e) Replace in reverse order.
2 To Remove the Control Panel
Disconnect the appliance from the electricity supply.
a) Remove the pan supports/hotplate accessories and
burner caps.
b) Slacken the brass venturi at the centre of each burner.
c) Remove the control knobs from all taps.
25