Moving Your Cooker - Falcon 1092 CT Dual Fuel Mode D'emploi

Cleaning Brass Components
Uncoated natural brass is used as part of the
authentic finish and may tarnish with age.
To regain a polished finish, these areas should be
cleaned using a proprietary cleaner such as Brasso.
Stubborn marks on the aluminium burner rings can
be removed using a similar cleaning material. This
will also restore the polished finish.
Ovens
The shelf supports on the oven sides can be
removed for cleaning.
First remove the oven shelves then pull the top of
the shelf support up and away from the oven side
and then lift the support away from the locating
bracket in the oven side at the bottom.
The panels on the oven sides are fixed and cannot
be removed. They have been coated with special
enamel that partly cleans itself.
This does not stop all marks on the lining, but helps
to reduce the amount of manual cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the shelf
supports and wipe the panels with a lint free cloth
and hot soapy water. The panels should then be
dried and the oven heated at 200°C for about one
To refit the side support, first
locate the tag at the bottom
of the support in the slot in
the locating bracket in the
oven side.
Then locate the tops of the
side arms in the holes at the
top.
hour. This will ensure the Cook & Clean panels are
working effectively.
Don't use steel wool (or any other materials that
will scratch the surface). Don't use oven cleaning
pads.

Moving your cooker

Switch off the electricity supply.
The cooker is heavy; two people may be required
to move it.
The cooker is fitted with one roller at the front and
two at the back. There are also two screw-down
levelling feet at the front.
The front roller, designed for moving the cooker,
can be wound down. The levelling tool that
controls this roller should be in the storage drawer
compartment. If you cannot find the levelling
tool, contact your installer. See the start of the
'Installation' section of these instructions, where
they should have entered their details.
To remove the drawer
Pull the drawer forward. Lift up the ends of the
plastic clips (one each side) to release the catches
holding the drawer to the side runners and at the
same time pull the drawer forward and away from
the side runners.
For safety's sake push the drawer runners back out
of the way.
15
English