Conversion To Lp Gas - Falcon 1092 CT Dual Fuel Mode D'emploi

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Conversion to LP Gas

Servicing - warning
This conversion must be performed by a competent
person. After conversion the installation must comply
with the relevant regulations and also the local electricity
supply company requirements. Read the instructions
before converting this appliance.
Failure to convert the appliance correctly could invalidate
any warranty or liability claims and lead to prosecution.
This instruction must be used in conjunction with the rest
of the appliance instruction, in particular for information
on Standards, cooker positioning, connection hose
suitability etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Conversion
Disconnect from electricity and gas before servicing.
Check appliance is safe when you have finished.
This appliance is CAT II 2H3+. It is supplied set for G20
natural gas at 20millibar
A conversion kit for LP gas is supplied with the cooker.
Injectors
Remove pan supports and burner heads.
Burner head
Burner base
Undo the large brass nuts and remove the brass venturis
and brass rings.
Either:-
Use a long box spanner to access and remove the
old jets.
Or: -
Lift up the front of the hotplate top and prop it up.
The burner bases are now accessible - remove the
old jets.
Save the jets removed from the appliance for possible
future use. Fit the new jets; see the table for the correct
type.
SERVICING - WARNING
If you have lifted up the hotplate then carefully replace
it taking care not to damage or displace the ignition
electrodes or flame safety probes (arrowed) and replace
the rear fixing screws.
To convert the control taps
Pull off all the control knobs.
Open the oven door & grill door and remove the fixing
screws underneath the control panel.
Remove the 3 fixing screws at the top of the control panel.
Pull the control panel forward. Rest it on the open grill
door and the open right hand oven door
Brass venturi
The tap bypass screw is now accessible. Unscrew the tap
bypass screw.
Using a pair of long nose pliers carefully remove the
bypass screw and fit the correct replacement screw. See
Burner ring
table for correct size. Tighten the screw down.
Repeat for all the burner control taps.
Refit the control panel.
23