Installation; Dear Installer - Falcon 1092 CT Dual Fuel Mode D'emploi

English

Installation

Dear Installer

Before you start your installation, please complete
the details BELOW.
If your customer has a problem relating to your
installation they will be able to contact you easily.
Thank you
Installer's Name
Installer's Company
Installer's Telephone number
You must be aware of the following safety
requirements & regulations
Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
The adjustment conditions for this appliance are stated on
the data badge.
This appliance shall be installed in accordance with the
regulations in force and only in a well ventilated space.
Read the instructions before installing or using this
appliance.
Provision of Ventilation
This appliance is not connected to a combustion products
evacuation device. Particular attention shall be given to
the relevant requirements regarding ventilation.
Location of Cooker
The cooker may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
NOTE:
An appliance for use on LPG shall not be
installed in a room or internal space below
ground level. e.g. in a basement.
Conversion
All models are supplied set for use on group H natural gas.
A conversion kit for Propane / butane gas is included with
the appliance. See the instructions that are supplied with
the conversion kit. After converting the appliance please
attach the Gas Conversion sticker over the appropriate
area of the data badge, this will identify the gas type the
appliance is now set for.
This appliance is designed for domestic cooking
only. Use for any other purpose could invalidate
any warranty or liability claim. You will need the
following equipment to complete the cooker
installation satisfactorily.
STABILITY BRACKET
If the cooker is to be supplied
with gas through a flexible hose, a
stability bracket or chain must be
fitted.
These are not supplied by with the cooker but
are available at most builders' merchants.
GAS PRESSURE TESTER
FLEXIBLE GAS HOSE
Must be in accordance with
the relevant standards.
MULTIMETER
(for electrical checks)
You will also need the following tools:
1. Electric drill
2. Masonry drill bit & Rawlplugs
(only required if fitting the cooker on a stone or concrete
floor)
3. Steel tape measure
4. Cross head screwdriver
5. Flat head screwdriver
6. Spirit level
7. Pencil
8. Adjustable spanner
9. Screws for fitting stability bracket
18