Falcon 1092 CT Dual Fuel Mode D'emploi page 14

English
Refit the centre ring.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS
THESE WILL DAMAGE THE SURFACE.
Glide-Out Grill
Before you remove any of the grill parts for
cleaning make sure they are cool.
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods that
soil, leave to soak for a few minutes in the sink
immediately after use. Stubborn particles may be
removed from the grid by using a nylon brush.
Alternatively, the grill pan can be washed in a dish
washer.
To remove the grill pan support frame, pull the grill
pan forward.
Lift the grill pan clear of the support frame.
The support frame is held to the side rails by two
clips on each side.
For each side, support the side rail with one hand
and with the other hand lift up and out of the side
clips.
For safety, push the side rails back into the grill
chamber.
The side rails can be removed to make cleaning the
grill chamber easier by unhooking them from the
grill chamber sides.
Slides can be wiped clean with a soft cloth and
mild detergent.
DO NOT use any abrasive substance.
DO NOT put the side runners in the dish washer.
When you have finished, hook the side rails back
on to the sides of the chamber. To refit the frame
pull the side rails forward and for each side in turn,
support the side rail and press the frame down in
to the side rails. Replace the grill pan.
Control Panel and Oven Doors
For best results, diluted liquid detergents should be
used.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water - but take care that no surplus
water seeps into the appliance. Wipe with a clean
dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft
cloth wrung out in clean hot soapy water.
14