Options And Accessories - Hatco 3CS Serie Manuel D'installation

English
WARNING
This unit must be serviced by trained and qualified
personnel only. Service by unqualified personnel may lead
to electric shock or burn.
Symptom
Water temperature too high.
Water temperature too low.
Heating elements burn out.
The sink or holding vessel leaks. Fittings are too loose or too tight.
The Power ON/OFF (I/O) toggle
switch is in the ON (I) position
but the unit is not heating the
water.
Temperature Monitor
An optional temperature monitor is available for 3CS Models.
The temperature monitor displays the current water temperature.
Temperature Light
An optional temperature light is available for 3CS Models. The
temperature light glows when the water temperature reaches
safe sanitizing temperature.
Low-Water Cut-Off
An optional low-water cut-off (LWCO) feature is available for
FR Models. This feature prevents element burn out from low
water conditions.
Form No. 3CSFRM-0415
Probable Cause
The water temperature control (FR only) is
set too high.
Water heaters need approximately 30
minutes to reach a safe sanitizing
temperature.
The water temperature control (FR only) is
set too low.
The sink or holding vessel is dry or has a low
level of water.
Deposits built up in heater are restricting
water flow.
The Low-Water Cut-Off
activated.
Fuses may be blown, the circuit breaker
may be tripped, or the power cord may be
unplugged.
TROUBLESHOOTING GUIDE
ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord/turn off power at circuit breaker, and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
Adjust the water temperature control (FR only)
to the desired temperature.
Wait 30 minutes for the unit to reach proper
temperature.
Adjust the water temperature control (FR only)
to the desired temperature.
Fill the sink or holding vessel with water to
normal operating level.
Perform the entire "Cleaning" procedure in the
MAINTENANCE section.
Adjust any fittings that may be causing the unit
to leak. Replace gasket, if necessary.
switch was The unit was shutdown due to a low water
level or from being overheated. Fill the heater
to the proper water level and turn the Power
ON/OFF (I/O) toggle switch to the OFF (O)
position and then to the ON (I) position.
Check for proper fuse sizing and replace
fuses, check/reset circuit breaker, and/or
check/replace power cord.

OPTIONS AND ACCESSORIES

Flush Hose Kit
The Flush Hose Kit is available for 3CS and FR Models and is
used to power flush the unit to keep it working at peak efficiency.
The kit consists of a drain stopper and a hose with adapter.
Security Package
A security package is a factory-installed option for 3CS and FR
Models. A security package contains Torx
cover.
Cord and Plug with Receptacle
An optional cord and plug with the matching receptacle is
available for FR-3 and FR-4 Models. Refer to "Plug
Configurations" in the SPECIFICATION section for more
information.
NOTE: Optional items are not field retrofittable.
17
WARNING
Corrective Action
screws and a control
®