9.3 Unlock the charging plug
The tasks described below may only be carried
out by a qualified electrician.
If the unlock function fails, the situation can occur that the
charging plug is mechanically interlocked by the actuator.
The charging plug cannot be removed and must be unlo-
cked manually.
Fig. 21: Unlocking the charging plug
f Open the device.
Î "5.4 Opening the device"
f Fit the red lever (2) on the square shaft of the actuator
(1). The red lever is attached with a cable tie close to
the actuator.
f Turn the red lever on the actuator 90° clockwise.
f Unplug the charging plug
f Remove the red lever and fasten it close to the actua-
tor with a cable tie.
f Close the device.
Î "6.7 Closing the device"
10 Taking out of service and
dismantling
The tasks described in this section may only be
carried out by a qualified electrician.
Taking the device out of service
f Open the device.
Î "5.4 Opening the device"
f Disconnect the supply line.
f If necessary, disconnect the line of the shunt release.
Dismantling the device
f Take the device out of service.
f Remove plugs and screws.
f Detach the device from the wall.
f Route lines out of the enclosure.
f Close the device.
Î "6.7 Closing the device"
11 Storage
Proper storage can positively affect and maintain the ope-
rability of the device.
f Clean the device before storing.
f Store the device in a clean and dry place in its original
or other suitable packaging.
f Observe permissible storage conditions.
Permissible storage conditions
Storage temperature
Average temperature over
24 hours
Relative humidity
-25°C... + 40°C
< 35 °C
max. 95 %
(non-condensing)
35
EN