Multifunction Button; Operating Modes; Led Info Bar - Mennekes AMTRON Manuel D'utilisation Et Guide D'installation

Masquer les pouces Voir aussi pour AMTRON:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 111

3.6 Multifunction button

For versions Professional+ 7,4 / 22 (PnC) only.
The residual current device and the miniature circuit
breaker in the device can be manually switched on again
from outside via the multifunction button. The residual
current device can be tested for functionality using the
multifunction button without opening the housing.
Fig. 8: Multifunction button

3.7 Operating modes

The device has three operating modes that can be chan-
ged even during operation.
The availability of the individual operating modes
depends on the configuration of the device.
The following operating modes are possible:
„ "Autostart"
The device is operated as a stand-alone solution wit-
hout connection to a Backend-System. An authorisati-
on is not required.
„ "Local Whitelist"
The device is operated as a stand-alone solution wit-
hout connection to a Backend-System. Authorisation
occurs via RFID cards and a local Whitelist.
„ "Backend-System"
The device is connected to the Backend-System via
OCPP. The device is operated via the Backend-System.

3.8 LED Info bar

The LED information field indicates the operating status of
the device. Standby, charging, wait time, and fault are indi-
cated by four symbols in the colours blue, green, white,
and red.
Symbol
Colour
Lights
Standby
up blue
The device is ready for use. No
vehicle is connected to the device.
flashes
Standby: Starting the charging
blue
process
„ Authorisation has occurred.
„ Authorisation has not occurred.
Lit
Charging
green
Charging in progress.
flashes
Charging: Excess temperature
green
warning
Charging in progress. The device
reduces the charging current to
prevent overheating and deacti-
vation.
steady
Wait period
white
„ The charging process on the
„ Waiting for authorisation.
flashes
Wait time: Removing the char-
white
ging cable
The charging process has finished.
Remove the charging cable.
lit or
Fault
flashing
A fault prevents the vehicle from
red
charging.
Î "9 Remedy"
The colours green and blue can be configured when the
device is commissioned.
Î "6.2.5 Advanced settings"
Operating state
No vehicle is connected to the
device.
A vehicle is connected to the
device.
device was ended. Waiting for
confirmation from the vehicle.
EN
9

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières