Güde GGH 10 Mode D'emploi Original page 9

•
If gas leakage remains, call an expert before re-
commissioning.
•
Assembly and maintenance of the device must
comply with laws and directives of a country
where the device is used.
•
Do never turn the gas cylinder upside down
even though you think it is empty! This
procedure may jam the hose with residues from
the gas cylinder and cause fire hazard and
immediate damage of the device.
•
Do not disassemble the protective grid and/or
other parts of the heater.
•
Keep children out of reach of the burner.
•
Do not operate the device without supervision!
•
Do not cover the device!
•
Do not use for drying of clothes etc.!
•
Do not touch the protective grid and thermal
shield, otherwise burning injury may occur!
Assembly and commissioning instructions (Fig.
A/B/C)
Do not use the device close to flames, sparks or
flammable substances (except for substances required
for operation - here propane/butane).
Operate the device on a flat and stable surface.
Step 1 (C/1)
Plug the device to a socket (230V~50Hz).
Step 2 (C/2)
•
Connect the reduction valve (B/7) with the gas
hose connection (B/8).
•
Connect the reduction valve (B/7) with the fitted
gas hose to the gas cylinder valve (B/12).
•
Connect the gas hose connection (B/9) with the
heater.
Step 3 (C/3)
Screw out the gas cylinder valve (B/12).
Check the screw closures by tightness test
spray or use a soap liquor. Retighten, if necessary.
Step 4 (Fig. C/4)
Press ON/OFF switch (A/6).
Step 5 (Fig. C/5)
From suction side check whether the fan (A/1) revolves.
Step 6 (Fig. C/6)
•
If the fan (A/1) revolves, keep the gas valve
button (A/11) pressed and at the same time,
press repeatedly the ignition button (A/5) until
the burner ignites.
•
Hold the gas valve button (A/11) pressed for 10
to 20 more seconds.
•
Check whether the gas heater works
uninterruptedly.
Turning off (Fig. D)
Step 1 (Fig. D/1)
To turn the heater off, first screw in the gas cylinder valve
(B/12).
Step 2 (Fig. D/2)
Turn off the device with the use of ON/OFF switch (A6).
Step 3
Unplug the device from the socket to disconnect power
supply.
Replacement of gas cylinder
•
Always replace the gas cylinder outside and out
of reach of flames or flammable sources without
presence of other persons!
•
Close the gas cylinder valve. (B/12)
•
Screw out the reduction valve (7).
•
Ensure you have the reduction valve seal
available.
•
Connect the device to a new gas cylinder and
proceed according to instructions in "Assembly
and commissioning instructions".
Identification
Product safety:
The product complies with
relevant EU standards
Prohibitions:
No flame!
No smoking!
Warning:
Warning/caution
Caution! Dangerous electric
voltage!
Caution! Dangerous electric
voltage!
Commands:
General prohibition sign
Secure the gas cylinder
against falling
9
No operation in closed
spaces!
No pulling the plug!
Caution! Hot surface!
Use outside only, however,
protect against rain.
Read operation manual
before use
Unplug the device from
socked before opening or
maintenance