Start Measurement With Averaging Interval; Typical Applications - Hydac FluidControl Unit FCU 8000-1 Série Manuel D'utilisation Et D'entretien

Operating and Maintenance Instruction FCU 8000-1 series

7.3.3 Start measurement with averaging interval

Description
In this mode of operation, by contrast to point 7.3.1 "Inputting the measurement point
designation", an averaging interval can also be pre-set. Any value between 1 min and
1440 min (24 hours) in increments of 1 min can be programmed as the averaging interval.
Each current individual measurement value is always displayed for information on the
FCU display, however, only the average values of the measurements taken within the pre-
set interval are stored and printed out.
Operation
MEMORY key
Measurement point
Averaging interval
Selective deletion
Delete all
Change meas. point

Typical applications

Continuous long term monitoring and logging of the oil cleanliness on hydraulic systems.
memory
MEMORY
Meas. point
MEMORY
Averaging interval
MEMORY
ok
start
Averaging interval
HYDAC Filtertechnik GmbH
ok
start
ok Averaging interval:
start
10 min
ok
stop
start
E
Doc.: 3109776 Ed.: 01/13.02.2002
7 8 9
4 5 6
1 2 3
0
or
+
-
Page 106