Scope Of Delivery; Installation Sequence - RECARO P1300GT Instructions D'utilisation

3. Installation
NOtICE
The interplay between the racing shell and the
adapter is crucial to how the entire seat system
behaves.
„ Mount the RECARO P1300GT racing shell
only together with the independently tested
RECARO adapters 7221391 or 7308864.
Only this provides the necessary safety in
motor sports.
3.1. Positioning the racing shell in the vehicle
„ Select the most comfortable seat position for
yourself that is safest for driving the vehicle:
You must be able to completely hold the top
edge of the steering wheel without lifting yourself
out of the seat with your back.
Your knee must still be slightly angled when the
clutch or brake pedal is fully pressed.
„ Make sure that the restraint systems and
the roll cage are correctly installed (see the
manufacturer's installation instructions).

3.2. Scope of delivery

„ Check the scope of delivery for completeness
before installation.
Racing shell (Figure A)
(1) Racing shell, 1 ea.
(2) Back seat cushion, 1 ea.
(3) Front seat cushion, 1 ea.
(4) Replaceable pads, 9 ea.
(5) Mounting aid, 2 ea.
(6) Screw M8x25, 10.9, 4 ea.
Adapter 7308864 (Figure B)
(7) Adapter, 1 ea.
(8) Transport lock, 1 ea.
(9) Length adjustment lever, 1 ea.
(10) Screw M10x20, 10.9, 4 ea.
Adapter 7221391 (Figure C)
(11) Adapter, 2 ea.
(12) Screw M10x20, 10.9, 4 ea.

3.3. Installation sequence

Refer to Pages 3 to 5 for the associated
drawings.
Mounting adapters in the vehicle
NOtICE
The adapters must be secured in the vehicle
and the associated structural modifications to
the vehicle must be done in accordance with the
stipulations of the respective national motor sports
association or of the FIA and as per the applicab­
le version of the regulations that apply.
Fitting the mounting aid (Figure D)
„ Screw the mounting aid (5) into the racing shell
on both sides.
Mounting adapters in the vehicle
Adapter 7308864 (Figures E1, E2)
1. Lift the adapter (7) with the transport lock (8) into
the vehicle. The red length adjustment lever (9)
has to point to the door.
2. Mount the adapters (7) in the vehicle using at
least four M10 screws, strength class 10.9.
Tightening torque: 35 Nm.
3. Dismantle the transport lock by loosening the 4
screws (10).
Adapter 7221391 (Figure F1)
„ Mount the two adapters (11) in the vehicle using
at least four M10 screws, strength class 10.9.
Tightening torque: 35 Nm.
Mounting the racing shell
1. Thread the racing shell with the pin (13) at the
front in the hook of the adapter (Figures E3 and
F2).
2. Define the seat angle by selecting the front holes
(Figure G). Fix the seat angle using 2 screws
M10x20 (10 and 12) on each side (Figure H).
Do not tighten the screws yet!
3. Lower the racing shell until the mounting aids
are positioned on the adapters (Figure I).
4. Fasten the racing shell in the rear section with 2
screws M8x25 (6) on each side (Figure H). Do
not tighten the screws yet.
13