Cleaning And Care; Cleaning The Cover - RECARO P1300GT Instructions D'utilisation

4. use
Safety instructions before you start driving
DANGER
there is a danger to life if a damaged racing
shell is used when the car is driven!
„ Carefully inspect the racing shell and the
adapter for damage such as cracks, bumps,
dents or similar defects before every use.
„ If you find any damage, consult a specialist
motor sport workshop.
„ If there is damage that can affect safety, re­
place the racing shell immediately and make
sure that the damaged racing shell will not be
put back into a vehicle.
DANGER
Danger to life if a racing shell is used that is
no longer approved!
„ Use the racing shells for no longer than is
stated on the homologation sticker
(Not valid after: xxxx).
„ After this date the racing shells may never
again be used in a vehicle.
Homologation sticker
DANGER
there is a danger to life if a racing shell that
has been involved in an accident is used!
„ Racing shells that have been subjected to the
stresses of an accident (racing accident or col­
lision) must no longer be used.
„ Make sure that the damaged racing shell will
not be put back into a vehicle.

5. Cleaning and care

NOtICE
the following cleaning and care suggestions
are non-binding instructions. RECARO as-
sumes no liability for these suggestions.
„ Follow the instructions for using the particular
care or cleaning agent.
„ First test the effects of a care or cleaning agent
in an inconspicuous place before you treat the
entire seat with the agent in question.

5.1. Cleaning the cover

Basic cleaning
„ Use a standard dry foam cleaner to clean the
cover of your RECARO racing shell after it has
been in use for a long time. This freshens up
the cover and restores the original shine to the
colours.
„ Always clean the entire surface and not just indi­
vidual areas. This prevents unattractive edges.
„ Allow the covers to dry for at least 48 hours after
cleaning.
Removing dirt stains
„ Remove dirt patches immediately if possible.
„ Clean the cover with a standard commercially
available dry foam cleaning agent or a mild
detergent.
„ Avoid vigorous rubbing with aqueous solutions
as this will roughen the fabric surface.
5.2. Cleaning the racing shell
NOtICE
Solvents can damage the racing shell!
„ Do not use any solvents (e.g. cleaning sol­
vents) to clean the racing shell.
„ Make sure that the racing shell does not come
into contact with solvents.
„ Use a mild soap solution to clean the racing
shell. To do this use a moist sponge.
15