ETNA T300 Notice D'utilisation page 54

A
1. Check if the kitchen cabinet and the cut out
are in accordance with the instructions
(see 'safety' and 'building in dimensions').
2. Remove the protective foil of the sealing
strip (A) and attach the sealing strip in the
groove of the aluminium profiles or the
edge of the glass plate. Do not attach the
sealing strip through the corner. Instead,
cut 4 pieces that fit tightly together in the
corners.
3. If the woodtop is made of treated wood,
then coat the sawn surfaces of the top with
sealing varnish, to prevent moisture
causing the top to swell.
4. Turn the appliance over and put it in the
cutout.
5. Connect the appliance to the electricity
supply. The displays will illuminate and in
the timer display the text "Co" will appear.
The displays will extinguish after a short
time.
6. Check its operation. If the appliance has
been connected incorrectly, it will emit a
beep signal or the displays will not
illuminate.
7. Hand over the instructions to your
customer.
Immediately after switching on the fan
will start. The appliance will now carry
out a self-check for a few seconds.