Disposal Of Packaging And Appliance; General - ETNA T300 Notice D'utilisation

Disposal of packaging and
appliance
The appliance packaging is recyclable.
The following may have been used:
■ cardboard;
■
polythene film (PE);
■ CFC-free polystyrene (PS hard foam).
Dispose of these materials responsibly and in
accordance with government regulations.
On the data plate is put the symbol of a
crossed-out wheeled dustbin:
This means that at the end of its working life,
the product must not be disposed of as urban
waste. It must be taken to a special local
authority differentiated waste collection
centre or to a dealer providing this service.
Disposing of a household appliance
separately avoids possible negative
consequences for the environment and health
deriving from inappropriate disposal and
enables the constituent materials to be
recovered to obtain significant savings in
energy and resources.
As a reminder of the need to dispose of
household appliances separately, the product
is marked with a crossed-out wheeled
dustbin.

General

This appliance meets all relevant CE
guidelines.
The data plate on the underside of the
appliance indicates the total nominal load, the
required voltage and the frequency.
Safety
This appliance should only be connected up
by a registered electrical installer! The
electrical connection must comply with
national and local regulations.
The appliance should always be
earthed.
Damage caused by incorrect connection,
incorrect use or incorrect building in is not
covered by the guarantee.
For correct operation of the appliance it is
important that:
■ the power cable hangs freely and is not
struck by a drawer;
■ the worktop is level.
The walls and the worktop around the
appliance must be made of heatresistant
(>85°C) material. Even if the appliance itself
does not get hot, the heat from a hot frying
pan, for instance, could cause discolouring or
damage to the wall or worktop.