Resetting The Code Button - Becker Centronic EasyControl EC513 Notice De Montage Et D'utilisation

Resetting the code button

Attention
The opening code is cleared and a new code must be created
following the reset. The programming code is reset to fact-
ory setting. The code specifically preset for the code button
is included in delivery with the product.
The programmed receivers are not cleared.
1 2 3
4 5 6
7 8 9
P 0
+
28 - en
Press any number button for approx. 5 seconds.
▻ The LED goes out.
Remove the batteries within 30 seconds and then re-
place them.
Press the "P" and "Key" buttons simultaneously within 30
seconds and hold for at least 3 seconds.
▻ The LED flashes slowly.
Now press the "Key" button.
▻ The LED goes out.
► The code button is reset.