Programming.the.remote.control - Becker Centronic UnitControl UCR520 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Moving to intermediate position
You.should.only.move.the.shutter.or.blind.to.the.intermediate.position.or.pro-
gramme.it.from.the.upper.end.limit.
Press.the.DOWN button.twice in.rapid.succession..The.awning.will.move.to.the.
stored.intermediate.position.
Moving to ventilation position
You. should. only. move. the. shutter. or. blind. to. the. ventilation. position. or. pro-
gramme.it.from.the.lower.end.limit.
Press. the. UP button. twice in. rapid. succession.. The. awning. will. move. to. the.
stored.ventilation.position.
Moving to reverse position (venetian blind)
When.the.venetian.blind.function.is.being.used,.the.blind.moves.in.nonmaintained.
command.mode.in.order.to.allow.the.slats.to.be.positioned.more.precisely..If.you.
press.and.hold.a.control.button.for.longer.than.1.second,.the.blind.will.remain.
locked.
After.the.programmed.intermediate.position.has.been.reached,.the.slats.will.be.
automatically.adjusted.(provided.the.reverse.position.has.been.programmed).
Programming the remote control
Setting the UCR520 to programming mode
a) Set the UCR520 to programming mode by switching on the power sup-
ply
Switch.on.the.power.supply.
The.UCR50.will.remain.in.programming.mode.for.3.minutes.
b) Set the UCR520 to programming mode using the programming button
Press.and.hold.the.programming.button.for.3.seconds.
The.control.light.indicates.that.the.programming.mode.has.been.activated.
The.UCR50.will.remain.in.programming.mode.for.3.minutes.
Programming master transmitter
Press.and.hold.the.programming.button.of.the.transmitter.for.3.seconds.while.
in.programming.mode.
The. system. will. confirm. the. programme. setting. with. a. 'nod',. i.e.. the. shutter/
awning/blind.moves.a.few.centimetres.in.one.direction.and.then.reverses.the.
same.distance.
This.confirmation.is.hereafter.referred.to.as.'nodding'.
The.programming.process.is.now.complete.
4