Clear Code Button - Becker Centronic EasyControl EC513 Notice De Montage Et D'utilisation

A programming code is necessary for this procedure. This code can be found
in the enclosed information sheet.
24 - en

Clear code button

Put the receiver into programming mode using the mas-
ter transmitter.
Always observe the assembly and operating in-
structions of the master transmitter.
Press the "P" button for at least 3 seconds.
▻ The LED flashes slowly.
Enter the programming code (e.g. 1234). The code spe-
cifically preset for the code button is included in delivery
with the product.
▻ The LED flashes slowly.
Now press the "Key" button.
▻ The LED lights up.
Now select the required channel via the 1, 2 or 3 buttons.
▻ The blue LED lights up.
Now press and hold the "Key" button.
▻ The receiver confirms once.
Now press and hold the "Key" button again.
▻ The receiver confirms twice.
► The receiver has now been cleared.