Actuating The Code Button - Becker Centronic EasyControl EC513 Notice De Montage Et D'utilisation

Actuating the code button

An opening code must first be entered in order to operate a receiver using the
code button. The factory setting for this is "1111". The user can change the
opening code individually to a different number combination.
Enter the opening code. (Factory setting 1111)
▻ The LED lights up briefly at each input.
Now press the "Key" button.
▻ The LED lights up.
Depending on the channel, you can now operate the re-
ceiver using the UP (1, 2, 3), STOP (4, 5, 6) or DOWN (7,
8, 9) buttons.
Commands can only be input when the LED is ac-
tivated.
Press the "Key" button to disable the code button manu-
ally.
▻ The LED goes out.
► Operation is complete.
The code button automatically disables the but-
tons after approx. 20 seconds.
25 - en