Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
■ Lens care
• Be careful not to allow the CPU contacts c to
become dirty or damaged.
• If the lens mount rubber gasket b is damaged, be
sure to visit the nearest Nikon-authorized service
representative for repair.
• Clean lens surfaces with a blower brush. To remove
dirt and smudges, use a soft, clean cotton cloth or
lens tissue moistened with ethanol (alcohol) or lens
cleaner. Wipe in a circular motion from the center to
the outer edge, taking care not to leave traces or
touch other parts of the lens.
• Never use organic solvent such as thinner or benzene
to clean the lens, as this could cause damage, result in
a fire, or cause health problems.
• NC filters are available to protect the front lens
element. The lens hood also helps to protect the front
of the lens.
• When storing the lens in its flexible lens pouch, attach
both the front and rear lens caps.
• When the lens is mounted on a camera, do not pick
up or hold the camera and lens by the lens hood.
• When the lens will not be used for an extended
period of time, store it in a cool, dry place to prevent
mold and rust. Be sure to store the lens away from
direct sunlight or chemicals such as camphor or
naphthalene.
• Do not get water on the lens or drop it in water as this
will cause it to rust and malfunction.
• Reinforced plastic is used for certain parts of the lens.
To avoid damage, never leave the lens in an
excessively hot place.
■ Standard accessories
• 72mm snap-on Front Lens Cap LC-72
• Rear Lens Cap LF-1
• Bayonet Hood HB-35
• Flexible Lens Pouch CL-1018
■ Optional accessory
• 72mm screw-on filters
En
19
Publicité
Table des Matières
