Earthing - Palazzetti WT R/L Série Manuel D'installation

In Fig. 5.4 shows by way of example one assembly
diagram.
A) Chimney;
B) Outside air intake;
C) Heat recovery grate;
D) Fireproof hood and load-bearing structure;
E) Flue gas duct;
F) Shield the wooden parts with flame retardant
material.
If the appliance is installed on a flue that had previously
been used by other fireplaces, it is necessary to
perform thorough cleaning to avoid anomalous
operations and to prevent the possible burning of
unburnt substances that are deposited on the internal
walls of the same.
Incorrect installation can compromise the safety of
the appliance.
The cladding must be made of fireproof material.

5.5 Earthing

The appliance is provided with screw for equipotential
coupler that can receive a cable with cross-section
from 2.5 mm to 6 mm
2
the equipotential bonding of the earth in accordance
with the rules in force. This coupling is located in the
back of the fireplace and indicated with the symbol
(Fig. 5.5)
* For Italy these technicians must have the
licence as per letter "C" issued by the Chamber
of Commerce according to M.D. 37/08.
30
, that can be used to obtain
2
004778150 - 18/08/2020
C
D
Product images are purely indicative
E
A
B
F
Fig. 5.4
Fig. 5.5