Installing Clevises On Control Horns And Control Centering; Factory Settings; Control Direction Test - PARKZONE P-51D MUSTANG BL RTF Manuel D'utilisation

Installing Clevises on Control Horns and Control Centering

Tip: Turn the clevis clockwise or counterclockwise on the linkage.
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis and put the clevis pin in a selected
hole in the control horn.
• Move the tube to hold the clevis on the control horn.
After binding a transmitter to model receiver, set trims and
sub-trims to 0, then adjust clevises to center control surfaces.

Factory Settings

Fly the model at factory settings before making changes. For pilots who
wish to fly model for advanced aerobatics, adjust position of linkages
Arms
on control horns for increased travel.

Control Direction Test

Horns
CAUTION: Keep your hands, loose clothing,
hair and any other item clear of the propeller before
starting the control test in the event that you
accidentally turn on the motor.
CAUTION: Always disconnect the
battery before powering off the transmitter.
Ailerons
Rudders
Arms
Horns
Mode 2
Right Aileron (using Aileron stick)
Left Aileron (using Aileron stick)
Down Elevator
Up Elevator
1.
2.
3.
Ailerons Rudders
Arms
Ailerons Elevators Ailerons
Mode 1
4.
5.
6.
Horns
Elevators
EN
7