Fitting The Cover Plate; Adding Grinding Fluid - Fronius TIG Grinder Instructions De Service

Fitting the cover
plate
Adding grinding
fluid
68
(1) (2) (3) (4) (5) (6)
(1)
Clean the seal between the viewing
1
window and the housing
Fit the viewing window and cover plate
2
Tighten the Allen screws (1) - (6) on
3
the cover plate using a 2.5 mm Allen
key
Tightening torque = 0.5 Nm
Check that the key is holding the tank
1
securely in place
Pour the grinding fluid for the grinder
2
through the guide bushing
The fluid level must lie between the mi-
3
nimum mark (1) and the maximum
mark (2)
(2)
NOTE! Some of the grinding fluid
will be taken up by the disc.
Always check the fluid level before
using the device and adjust if nec-
essary.