Fitting The Ml Torch Body To The Mhp Hosepack; Assembling The Multilock Welding Torch - Fronius MTG 250d Instructions De Service

Fitting the ML torch body to the MHP hosepack

Assembling the
NOTE!
Multilock welding
torch Risk of damage to the welding torch. Always tighten the union nut on the torch
body as far as it will go.
NOTE!
In the case of water-cooled welding torches, increased resistance may arise when
tightening the union nut due to the construction of the welding torch. This is nor-
mal. Always tighten the union nut on the torch body as far as it will go.
NOTE!
Before fitting a torch body, ensure that the interface between the torch body and
the hosepack is clean and undamaged.
1
2
*
46
(A) (B)
(A)
(B)
Ensure that the union nut is tightened as far as it will go.
NOTE!
The torch body is in the 0° position
when the dowel pin (A) on the
hosepack engages in the locating hole
(B) in the torch body.
3