Changing The Grinding Track; Draining The Grinding Fluid - Fronius TIG Grinder Instructions De Service

Changing the
grinding track
Draining the
grinding fluid
(1)
(1) (2) (3)
(2)
Undo the Allen screw (1) using a
1
2.5 mm Allen key
Turn the guide bushing (2) by one
2
notch (3).
Tighten the Allen screw (1)
3
Tightening torque = 0.5 Nm
Remove the drain hose (2) from the
1
collecting cup on the left side of the de-
vice
NOTE! Hold the hose higher than
the fill level indicator. Otherwise
grinding fluid will escape as soon
as the seal (1) is opened.
Open the seal (1)
2
Put the hose into a receptacle with a
3
minimum capacity of 500 ml
(3)
Hold the receptacle with the hose lo-
4
wer than the top edge of the tank (3) for
the grinding fluid.
Allow the grinding fluid to escape
5
Once the grinding fluid stops escaping
6
from the hose, close the seal (1) again
65