hawa Alcu-Press 2605 Notice D'utilisation Originale page 18

Installation of the punching tool (fig. 7+8):
Select the matching punch size according to the recommendations of your
busbar supplier.
Insert the punch (5) into the punch holder (6) and press on the rubber wiper (7) (see fig. 7+8).
Insert the die holder into the cylinder piston shaft and fix the punch with the threaded pin
(item 2 in fig. 6)
Insert the matching die into the die holder and fix it with the laterally mounted
threaded pin.
Push the die holder from the front into the tool holder (4).
Fix the die holder with the locking pin (see item 1 in fig. 6).
Workpieces with short hole distance
Use the separate wiper for punching hole series with short hole distance to prevent the
workpiece from bulging. The separate wiper is included in the scope of delivery.
7.3 Operating Instructions for the Use of Separate Wipers
Can only be used for the function "punching". Order no.: 2605-7500-25-00
Fig. 9
1.2
1.1
A
Insert the punch (2) from above into the retaining plate (1) of the separate wiper (fig. 9). Optically align the cylindrical pin (2.1) of the shaped punch (2)
according to the markings (1.2). Secure the punch with the threaded pin (3).
When working with the separate wiper, the groove (1.1) ensures that the emitted laser line remains visible on the workpiece.
Insert the clamping pin of the punch (2) into the cylinder piston shaft and secure the separate wiper with the threaded pin (item 2 in fig. 6).
Note:
Install the separate wiper in the Alcu-Press with the laser beam cut-out (1.1) facing the operator
(A = operator view = fig. 9)
CAUTION:
Mount the finger guard "without knurled nut".
18
Fig. 7
2 2.1
1
3
Fig. 8
5
6
7