Operating Instructions For Line Laser Module; Technical Data And Limits Of Use; Accessories; Inspection / Maintenance / Cleaning - hawa Alcu-Press 2605 Notice D'utilisation Originale

1
1
Fig. 23
Operating instructions for the shut-off unit:
Mount the "length adjustment device complete" as shown in fig. 23+24. Switch the electro-hydraulic pump to set-up mode (program 2). Insert the first
workpiece of the series and operate the foot switch until the required bending angle is achieved(see also item 7.4/7.5).
Now guide the cam (4.1) to the contact point of the position switch and fix it with the knurled screw (4.2).
Retract the piston shaft (see operation manual electro-hydraulic pump) and remove the workpiece.
Set the electro-hydraulic pump to series mode (program 1). The stroke ends at the same position and the return stroke starts automatically.
7.8 Operating Instructions for the Line Laser Module
Order No. line laser module:
Order No. power unit:
When punching with the line laser module, the workpiece can be positioned longitudinally to a previous marking on the workpiece.
Use the depth stop for transverse direction. When cutting to length, the line laser module is without function.
Note:
During long interruptions, we recommend to switch off the line laser module to ensure a longer service life.
8. Technical Data and Limit of Use
Suitable materials:
Function "Punching":
Punching:
Material thickness:
Processing depth:
Depth stop:
Laminated copper:
Function "Cutting to Length + Bending + Trimming":
Workpiece dimensions:
Cylinder force:
Cylinder stroke:
Max. admissible hydraulic pressure:
Weight:

9. Accessories

You will find suitable accessories on our website under http://www.haewa.com
(Enter the order number of your product and go to the "Accessories" tab.).

10. Inspection / Maintenance / Cleaning

CAUTION:
Before any servicing and repair work, ensure that the unit is depressurized and the pump is disconnected.
• Before starting work, check the equipment visually (machine/tool, hydraulic pump with hydraulic hose).
• Avoid any contamination of the hydraulic system (use the dust cap after uncoupling).
• Clean the machine/tool in regular intervals.
• Dispose of oily rags and hydraulic oil as hazardous waste.
22
A
A
2
2
(Laser rating 2)
2600-2000-00-11
2600-2000-60-11
Copper and aluminum
ø 17 mm / oblong hole 22x13 mm
max. 12 mm
85 mm
8 – 85 mm
with customized punching tools
max. 120x12 mm
270 kN
41 mm
450 bar
163 kg
Fig. 24
4.2
5 5 4.1 4.1 4.2 6 6 3 3
DETAIL A
DETAIL A
Fig. 25
4 4