Operating Instructions For Cutting To Length; Operating Instructions For Punching - hawa Alcu-Press 2605 Notice D'utilisation Originale

CAUTION:
Safety devices may only be removed for adjustments.
7.1 Operating Instructions for Cutting to Length (Fig. 2+3)
Cutting tool: 2605-0508-01-20 (accessories)
Installation of the cutting tool:
Insert the cutting blade into the die and push the tool from the front into the tool holder (4).
Fix the die with the locking pin (1).
Insert the clamping pin of the cutting blade into the cylinder piston rod and secure the cutting blade with the threaded pin (2).
CAUTION:
When operating the machine, fix the finger guard "with knurled screw".
Do not use the cutting tool for cutting laminated copper rails.
Setting and cutting:
Adjust the depth stop (3) that the rail to be cut is positioned in the center of the shear blade (fig. 2+3).
Set the required length dimension and insert the rail until it stops.
Operate the foot switch of the hydraulic pump until the rail is cut off.
Fig. 2
3
7.2 Operating Instructions for Punching (Fig. 4–6)
Punch tool holder (accessories) consisting of:
• Die holder ø 40 for Alcu-Press
• Adapter Alcu-Press for punching
Note:
• When punching, please ensure that the rail thickness does not exceed the hole diameter (fig. 4).
• Ensure a continuous cutting clearance (fig. 5).
• Ensure that cutting and punching scraps can freely fall down (fig. 6).
• Laminated copper rails can be punched with customized dies. Please contact your local sales office.
Fig. 4
Fig. 3
2
4
1
2605-0507-01-15
2605-0507-01-10
Fig. 5
0,3-0,5
0,01"-0,02"
Fig. 6
2
4
17