Operating Procedure; Passing The Thread - JUKI LB-6 Manuel D'utilisation

& . OPERATING PROCEDURE
Check the following items so as to avoid malfunction/damage of/to the machine.
• Clean up the machine before putting the machine into service for the first time after the set-up.
• Remove dust accumulated on the machine during transportation and lubricate it.
• Check to be sure that the voltage is set to a correct value.
• Check to be sure that the power plug is properly connected.
• Never use the machine with any voltage specification different from the correct one.
• Refer to the standard instruction manuals for the respective models of machines for lubrication, installa-
tion of the needle, adjustment of presser foot pressure, removing the presser foot, adjustment of stitch
length, adjustment of differential feed, adjustment of knife and overedging width, cleaning of the machine
head, and cleaning and replacement of filter and pump net.

1. Passing the thread

WARNING :
To protect against personal injury due to abrupt start of the machine, conduct maintenance works with
the power turned off.
38
Thread the machine head as illustrated.
(A threading diagram is adhered also in the
rear side of the looper cover.)