Cleaning Stainless Steel Surfaces; Troubleshooting; Induction Generator Fault Indicator - Salvis Master VisionPRO Mode D'emploi

4.3

Cleaning stainless steel surfaces

. Wash off the cleaned parts thoroughly after using harsh cleaning products.
. Clean stainless steel surfaces with grease‐dissolving cleaning products or special stainless
steel cleaners.
. Rub cleaned parts and surfaces dry with a soft cloth.
5.

Troubleshooting

If faults should occur on this appliance, check them using the following table:
Fault
The green indic­
ator light or the il­
luminated ring
does not light up
when the appli­
ance is switched
on.
If you cannot resolve the fault,
− turn off the appliance and disconnect from the mains power,
− do not open the housing,
− contact customer service.
5.1

Induction generator fault indicator

Fault message display
− The mains indicator lamp lights up for approx. one second.
− This is followed by rapid flashing signals.
− The lighting and flashing processes are repeated.
The flashes must be counted. The number of flashes indicates the error code. The error can be
determined from the table below.
Number of
flashes
1
2
Possible cause
Main switch on front of the appli­
ance is not turned on.
There is no power supply at all.
The circuit breaker has tripped.
Fault Cause
No power being Coil or power PCB
generated faulty
No power being Coil or power PCB
generated faulty
Remedy
Turn on the main switch.
Notify
the electricity supply company.
Have possible appliance faults checked
by an authorized customer service agent.
Reset the circuit breaker.
Action
Contact the authorised Customer Ser­
vice agent.
Contact the authorised Customer Ser­
vice agent.
en
17