Completion Of Operation; Cleaning And Care - Salvis Vario GN 1/1 Mode D'emploi

en
3.

Completion of operation

. Turn rotary switch to the 0 position.
D The indicator light or the illuminated ring goes out.
Add-on equipment radiant heater (chip pan)
. Turn rotary switch to the 0 position.
D The indicator light or the illuminated ring goes out.
. Clean the appliance, see the 4. "Cleaning and care" section below.
. Turn off the mains switch.
4.

Cleaning and care

Notes
D Do not apply any caustic cleaners to the control panel or rotary switches.
D Do not spray off or clean the appliance with water hoses, high-pressure cleaners, high-pres­
sure steam cleaners or general steam cleaners.
D Follow the instructions supplied by the manufacturer of the cleaning product.
D Do not use abrasive cleaning agents.
D CAUTION Corrosion or pitting damage to the tank caused by cleaning materials. Do not
leave detergents in the tank for a long time.
D Stainless steel must not be in prolonged contact with concentrated acids, vinegar essence,
salt solution, mustard or spice mixtures, otherwise the protective coating will be corroded.
After use, rinse stainless steel surfaces until water runs clear.
D
treated improperly! Therefore, you must remove lime, grease, starch and protein layers reg­
ularly. Under these layers, corrosion may build up to the lack of air. In extreme cases, the
tub or the tank can be destroyed by pitting to an extent that it may become unusable! The
manufacturer will not be held liable for damages caused by corrosion or pitting!
Cleaning and care products
Suitable cleaning and maintenance products can be obtained from your customer service.
These include e.g.:
− grease-dissolving cleaning products or special stainless steel cleaners
− Protective stainless steel cleaners
26 / 56
ATTENTION! Stainless steel may be destroyed! Even stainless steel will rust if it is