Cleaning Stainless Steel Surfaces; Troubleshooting; Technical Specifications; Griddle Pan - Salvis VP604300 Mode D'emploi

4.4

Cleaning stainless steel surfaces

. Clean stainless steel surfaces with grease-dissolving cleaning products or special stainless
steel cleaners.
. Wash or rinse the cleaned surfaces thoroughly with clean water and dry with a soft cloth.
5.

Troubleshooting

If faults should occur on this appliance, check them using the following table:
Fault
The green indic­
ator light or the
ring does not light
up when the ap­
pliance is
switched on.
The appliance is
switched on but
does not heat up.
If you cannot resolve the fault,
− turn off the appliance and disconnect from the mains power,
− do not open the housing,
− contact customer service.
6.

Technical specifications

We reserve the right to make technical changes
6.1

Griddle pan

Technical specifications
Item no.
Total connected load
Voltage
Fuses
Overall thermal output
Steam output
Appliance noise level
Possible cause
Main switch on front of the appli­
ance is not turned on.
There is no power supply at all.
The circuit breaker has tripped.
An upstream energy optimising
unit is not switching on the heat­
ing.
Griddle pan, single zone
VP604000, VP604010
MA604000, MA604010
4 kW
400 V 2N 50/60 Hz
2 x 16 A
2.3 kW
1.9 kg/h
less than 70 dB (A)
Remedy
Turn on the main switch.
Notify
the electricity supply company.
Have possible appliance faults checked
by an authorised customer service.
Reset the circuit breaker.
Check the energy optimising unit.
Griddle pan, dual zone
VP604050, VP604100, 881109
MA604100, MA604050
8kW
400 V 3N 50/60 Hz
3 x 20 A
4.7 kW
3.8 kg/h
less than 70 dB (A)
en
21 / 44