Troubleshooting Guide - MIRKA ROS Mode D'emploi

Symptom
Low power and/or low free
speed.
Air leakage through the Speed
Control and/or Valve Stem.
Vibration/rough operation.
DOC 0329

Troubleshooting Guide

Possible Cause
Insufficient air pressure.
Clogged muffler)s(.
Plugged Inlet Screen.
One or more worn or broken Vanes.
Internal air leakage in the Motor Housing
indicated by higher than normal air con-
sumption and lower than normal speed.
Motor parts worn.
Worn or broken Spindle Bearings.
Dirty, broken or bent Valve Spring, Valve
or Valve Seat.
Incorrect Pad.
Addition of interface pad or other material.
Improper lubrication or build-up of foreign
debris.
Worn or broken rear or front Motor
Bearing(s).
For vacuum machines it is possible to
have too much vacuum while sanding on a
flat surface, causing the pad to stick to the
sanding surface.
Check air line pressure at the inlet of the Sander
while the tool is running at free speed. It must be
6.2 Bar (90 psig/620 kPa).
See the "Housing Disassembly" section for Muffler
removal. The Item 38 Muffler can be back-flushed
with a clean, suitable cleaning solution until all con-
taminants and obstructions have been removed.
If the Muffler cannot be properly cleaned then
replace it. Replace Item 39 Muffler Insert )see the
"Housing Assembly" section(.
Clean the Inlet Screen with a clean, suitable
cleaning solution. If the Screen cannot be cleaned,
replace it.
Install a complete set of new Vanes (all vanes must
be replaced for proper operation). Coat all vanes
with quality pneumatic tool oil. See "Motor Disas-
sembly" and "Motor Assembly".
Check for proper Motor alignment and Lock Ring
engagement. Check for damaged O-Ring in
Lock Ring groove. Remove Motor Assembly and
Re-install the Motor Assembly. See "Motor Disas-
sembly" and "Motor Assembly".
Overhaul Motor. Contact authorized Mirka Service
Center.
Replace the worn or broken Bearings. See "Shaft
Balancer and Spindle Disassembly" and "Spindle
Bearings, AirSHIELD™ and Shaft Balancer As-
sembly".
Disassemble, inspect and replace worn or dam-
aged parts. See steps 2 and 3 in "Housing Disas-
sembly" and steps 2 and 3 in "Housing Assembly".
Only use Pad sizes and weights designed for the
machine.
Only use abrasives and/or interfaces designed for
the machine. Do not attach anything to the Sander
Pad face that was not specifically designed to be
used with the Pad and Sander.
Disassemble the Sander and clean in a suitable
cleaning solution. Reassemble the Sander. (See
"Service Manual".(
Replace the worn or broken Bearings. See "Motor
Disassembly" and "Motor Assembly".
For DB machines, add extra washer(s) to the pad
spindle to increase the gap between the pad and
shroud. For CV machines reduce vacuum through
the vacuum system and/or add extra washer(s)
to the pad.
31
Solution
Rev 07/01/16