LUXSAR VDRPJ10 Manuel D'utilisation page 99

Connect the Keyboard to PC:
Turn over the keyboard to the back, and set the HW Download Switch (as
STEP 1:
marked in the diagram below) to the left side (according to the diagram below).
Connect the port COM1 or COM2 of the PC and keyboard with a RS-232
STEP 2:
D-Sub9 cable (one-to-one, not a cross-over NULL-MODEM cable).
Start Firmware Upgrade:
STEP 1: Power ON the keyboard.
STEP 2: Start the firmware-upgrade Windows application.
STEP 3: Select «Download File» and then click «...» to select the download file.
STEP 4: Click the «Program Flash» button to start upgrading firmware.
STEP 5: There should be a status bar indicating the download percentage after clicking
the Program Flash
«
cable connection and software setting; then try again.
User's manual VDRPJ10 Version 2.3
button. If the downloading does not start, please check
»
48