Setting Through Camera Osd Menu; Sequence Function - LUXSAR VDRPJ10 Manuel D'utilisation

Go Preset Positions
Press a number key, such as <2>, and then press <GO PRESET> to go to
the defined preset position.
xxx P/T/Z/F/OSD Cam
Go Preset 002 . . .
6.3.2

Setting through Camera OSD Menu

Set Preset Positions
Press and hold the key <CAMERA MENU> to enter the OSD setup menu.
Then go to the page with the Preset setting item to set up preset positions;
for further details, refer to the dome camera's user manual. The OSD menu
shown below is for your reference; it would change subject to different
cameras.
ID DISPLAY
TITLE DISPLAY
TITLE SETTING
PRESET
SEQUENCE
AUTOPAN
CRUISE
Go Preset Positions
Select the preset point that you want to execute. After pressing <ENTER>,
the camera will turn to the appointed position.
6.4

Sequence Function

Under the Camera Control mode, users are able to operate the sequence
function. Before setting this function, users must pre-define at least two preset
positions. Please follow the instructions below to manipulate this function.
User's manual VDRPJ10 Version 2.3
MAIN PAGE 2
ON
OFF
01
ENTER
ENTER
ENTER
ENTER
18