Keyboard System Setting; System Linking; Keyboard Id Assignment; System Monitor - LUXSAR VDRPJ10 Manuel D'utilisation

5.

Keyboard System Setting

The Luxsar
<SYS> key and enter a correct password (default password is 0000). Detailed
operation will be described in the following sections. Please use ▲ (RUNSEQ)
and ▼ (SETSEQ) keys to scroll these setup items.
1.0 System Setting
Enter password [____]
5.1

System Linking

Item 1.1 allows users to scan connected dome cameras on the RS-485 bus;
fixed cameras will not be searched out. Please press ◄ or ► button to start a
new scanning session.
1.1 System Linking
Press ◄► to search
5.2

Keyboard ID Assignment

The item allows users to assign a new ID for this keyboard. Please press ◄ or
► key to change the ID number. The default ID of the control keyboard is 240.
Please assign different ID for different keyboard if more than one keyboard is
connected to one RS-485 bus.
1.2 Set Keyboard ID
(0 or 240-254): 240
NOTE: No two control keyboards connected to the same RS-485 bus
should be given the same ID.
5.3

System Monitor

Users could select a specific system monitor mode according to different system
structure. The options selectable include a. MPX main monitor, c. Super MPX
mode (Super Multiplexer) and d. Super MMX mode (Multiplexer-Matrix); b.
Matrix output is reserved. Generally, if there are less than 16 cameras within a
system, a. MPX main monitor would be a proper alternative. For a large-scaled
system, the connected cameras may exceed 16 or more. It is suggested to
select either the Super MPX mode or the Super MMX mode for such a situation.
Please refer to Appendix D: Super MPX and Super MMX System for further
details of Super MPX and Super MMX modes.
User's manual VDRPJ10 Version 2.3
VDRPJ10 will enter System Setup mode when users press the
10