Key Press Beep - LUXSAR VDRPJ10 Manuel D'utilisation

System Baud
Device
Type
Dome Camera
(DSCP)
Dome Camera
(Pelco-D)
Dome Camera
(Pelco-P)
DVR
(DSCP)
Basically, the camera ID here means camera number. This number is for users
to select a camera, which may be of fixed type or dome type, to display a
full-screen video output on the monitor through DVRs/MUXs. If this camera is a
dome camera, users can control and set this camera through RS-485
connection; each device on the bus should have a unique ID. The
VDRPJ10 needs to recognize whether a camera is of fixed type or dome type to
make correct control and setting. Please refer to Appendix C: ID Address
Mapping for information on camera ID and DVR/MUX channel mapping.
NOTE: If use a speed dome, ensure the camera No. and camera ID
(RS-485) are the same. Additionally, remember to assign a camera No.
to each fixed camera within the system, otherwise the fixed camera(s) won't be
searched out under the dome control mode.
5.10

Key Press Beep

The item allows users to turn on/off the key beep. When the setting is ON, the
key beeps when being pressed. Press ◄ or ► key to change the setting. Then
press ▼ to go to next item.
1.10 Key Press Beep
[OFF]
User's manual VDRPJ10 Version 2.3
Rate Default
9600
2400
4800
9600
ON
9600 4800
9600 4800
9600 4800
9600 4800
9600 4800
2400
2400
2400
2400
2400
Luxsar
14