Power On The Devices; Standby Mode Actions - LUXSAR VDRPJ10 Manuel D'utilisation

4.3

Power on the Devices

Please follow the steps to power up all devices.
(1) Connect all devices. Before connecting cameras and DVR to the system
control keyboard, please finish all protocol and unit ID setups.
(2) Power up all devices except for the keyboard. Make sure images of
connected cameras are displayed on the monitor screen.
(3) Power up the control keyboard.
As the keyboard is powered on, the software version will be displayed on the
LCD as shown below.
CCTV Controller
The (3-axis) keyboard LCD will display the date and time when the keyboard is
under standby mode.
CCTV Controller
2006/07/05 12:00:00
4.4

Standby Mode Actions

Users will be able to do the following actions under the Standby Mode.
•
Press the <SYS> key to enter the System Setup mode.
•
Enter the Camera Control mode by pressing <Camera/Dome Mode> key
camera OSD setup.
•
Enter the DVR/Multiplexer Control mode by pressing <DVR /Multiplexer
Mode> key
For detailed instructions on keyboard system setting, dome camera control and
DVR control, please refer to the following chapters.
User's manual VDRPJ10 Version 2.3
Version x.xx
and execute further camera controls such as P/T/Z operations and
and carry on further DVR control related settings.
9