Dome Camera Control; Entrance Into Camera Osd Menu - LUXSAR VDRPJ10 Manuel D'utilisation

6.

Dome Camera Control

To enter Camera Control mode, press the <Camera/Dome Mode> key
LED will be lightening. Then input the ID of the assigned dome camera and
press <ENTER> to confirm (see the column below).
Camera Control
Enter Camera No.:xxx
After confirmation, the LCD will display as shown below. Under the situation,
users could fully control the dome camera with the joystick.
xxx P/T/Z/F/OSD Cam
The first row of the LCD display above contains following information: P=Pan,
T=Tilt, Z=Zoom, F=Focus, OSD=OSD function available. The second row of the
display shows an input number under two kinds of situation. One is for users to
execute switch control among various dome/fixed cameras, with full-screen
video output via the DVR/MUX. For instance, if input <2> and press the
<ENTER> key, the camera no. 2 will be called out and the first row xxx displays
as 002; users could call dome/fixed cameras No. 1 to 223 by inputting a
corresponding number. Another situation is for preset and sequence setting;
further details will be described in the latter sections 6.3 Preset Function and
6.4 Sequence Function.
6.1

Entrance into Camera OSD Menu

To enter the camera's on-screen-display (OSD) menu, the keyboard should be
under the camera control mode, and the LCD should display as shown below.
xxx P/T/Z/F/OSD Cam
___
Press and hold the <CAMERA MENU> key (see the diagram below) for three
seconds to open the OSD menu of the camera if the selected camera is
equipped with the OSD function. In the OSD menu, users can make selection
and set various parameters with direction and <CAMERA MENU> keys. For the
camera with Pelco protocol, the joystick will function as directional control to
move the cursor in the Camera OSD.
For further details about cameras' OSD setup, please refer to cameras'
documentation.
User's manual VDRPJ10 Version 2.3
; its
16