Setting Through Camera Osd Menu; Cruise - LUXSAR VDRPJ10 Manuel D'utilisation

After completing speed setting, the LCD display would read 3.0. Press <1>
to run the Auto-Pan function. To exit the auto-pan mode, press <ESC>.
6.5.2

Setting through Camera OSD Menu

Set Auto-Pan Line
Press and hold the key <CAMERA MENU> to enter the OSD setup menu. Then
go to the page with the Auto-pan setting item to set up the Auto-pan lines; for
further details, refer to the dome camera's user manual. The OSD menu shown
below is for your reference; it would change subject to different cameras.
AUTOPAN LINE
START POINT
END POINT
DIRECTION
SPEED
RUN AUTOPAN
EXIT
Execute Auto-Pan Line
Move the cursor to the item of RUN AUTOPAN to run the auto-pan line.
6.6

Cruise

Under the Camera Control mode, users are able to operate the Cruise function.
Please follow the instructions below to manipulate this function.
User's manual VDRPJ10 Version 2.3
Execute Auto-Pan Line
xxx P/T/Z/F/OSD Cam
Running AutoPan...
AUTOPAN
1
TO FIND
TO FIND
RIGHT
01
ENTER
YES
24