TOHATSU MFS2.5B Manuel De L'utilisateur page 48

46
INSPECTION AND MAINTENANCE
1
1. Drain hole
4. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
18Nm (13 ft
-
ENON00028-A
Note
If a torque-wrench is not available when you
are fitting a oil filter, a good estimate of the
correct torque is 3/4 to 1 a turn past finger-
tight. Have the oil filter adjusted to the cor-
rect torque as soon as possible with a
torque-wrench.
5. Reset the engine in a vertical position.
10
6. Repeat 3 to 7 procedures two or three
times to drain the oil completely.
7. Remove the top cowl and the oil filler
cap.
8. Fill the engine through filler port with
recommended oil (see chart below) to
the middle of dipstick mark.
9. Tighten the oil filler cap.
ENOF01616-0
lb, 1.8 kgf m)
-
1
2
1. Oil filler cap
2. Engine oil drain screw
3. Engine oil level gauge
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
10W−40
10W−30
-30 -20 -10 0 10
-22 -4 14 32 50
Oil volume needed for complete oil replace-
ment
300 mL (10 fl.oz.)
3
ENOF00244-0
ENOF00245 0
20 30 40 ˚C
68 86 96 ˚F
ENOF00208-0