CONTENTS
OPERATION
1.
1.1
1.2
1.3
2.
Safety �������������������������������������������������������� 16
2.1
Intended use ����������������������������������������������������� 16
2.2
2.3
Test symbols ����������������������������������������������������� 17
3.
4.
Settings ����������������������������������������������������� 17
4.1
5.
6.
7.
Safety �������������������������������������������������������� 18
7.1
7.2
8.
8.1
8.2
Accessories ������������������������������������������������������� 18
9.
Preparations ������������������������������������������������ 19
9.1
9.2
10.
Installation �������������������������������������������������� 19
10.1
10.2
Power supply ���������������������������������������������������� 20
11.
11.1
Commissioning �������������������������������������������������� 20
11.2
12.
13.
14.
Maintenance ������������������������������������������������ 21
14.1
14.2
14.3
14.4
Descaling ��������������������������������������������������������� 21
14.5
14.6
14.7
15.
Specification ������������������������������������������������ 23
15.1
15.2
15.3
15.4
15.5
15.6
Data table �������������������������������������������������������� 25
ENVIRONMENT AND RECYCLING
www.stiebel-eltron.com
SPECIAL INFORMATION
- The appliance may be used by children aged 8
and up and persons with reduced physical, sen-
sory or mental capabilities or a lack of experience
and know-how provided that they are supervised
or they have been instructed on how to use the
appliance safely and have understood the result-
ing risks. Children must never play with the ap-
pliance. Children must never clean the appliance
or perform user maintenance unless they are
supervised.
- Only use a permanent connection to the power
supply. The appliance must be able to be sepa-
rated from the power supply by an isolator that
disconnects all poles with at least 3 mm contact
separation.
- The power cable must only be replaced (for
example if damaged) with the original spare
part by a qualified contractor authorised by the
manufacturer.
- Fix the appliance in position as described in the
chapter "Installation / Preparations".
- Observe the maximum permissible pressure (see
chapter Installation / Specification / Data table).
- The appliance is under pressure. During the heat-
up process, expansion water will drip from the
safety valve.
- Regularly activate the safety valve to prevent
it from becoming blocked e.g. by limescale
deposits.
- Drain the appliance as described in the chap-
ter "Installation / Maintenance / Emptying the
appliance".
- Install a type-tested safety valve in the cold water
supply line. For this bear in mind that, depending
on the static pressure, you may also need a pres-
sure reducing valve.
- Size the drain so that water can drain off unim-
peded when the safety valve is fully opened.
- Fit the discharge pipe of the safety valve with
a constant downward slope and in a room free
from the risk of frost.
- The safety valve discharge aperture must remain
open to the atmosphere.
PSH Trend |
15