OPERATION
Appliance description
2.2
General safety instructions
WARNING Burns
During operation, the tap and safety valve can reach
temperatures in excess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 8 and up and
persons with reduced physical, sensory or mental capa-
bilities or a lack of experience and know-how provided
that they are supervised or they have been instructed
on how to use the appliance safely and have understood
the resulting risks. Children must never play with the
appliance. Children must never clean the appliance or
perform user maintenance unless they are supervised.
Material losses
!
The user should protect the water lines and the safety
valve from frost.
Note
The appliance is under pressure. During the heat-up
process, expansion water will drip from the safety valve.
f If water continues to drip when heating is complet-
f
ed, please inform your qualified contractor.
2.3
Test symbols
See type plate on the appliance.
3.
Appliance description
The closed (pressure-tested) appliance heats DHW electrically.
You can adjust the temperature using the temperature selector.
Subject to the power supply, the water is heated automatically to
the required temperature.
The internal steel cylinder is coated with special "Co Pro" enamel
and is equipped with a protective anode. The anode protects the
internal cylinder from corrosion.
Frost protection
The appliance is also protected against frost by the temperature
setting "*", provided that the power supply is guaranteed. The
appliance switches on in good time and heats the water. The ap-
pliance does not protect the water supply lines and the safety
valve from frost.
www.stiebel-eltron.com
4.
Settings
The temperature can be freely adjusted.
1
2
1
ON/OFF indicator
2
Temperature selector
*
Frost protection
E
Recommended energy saving position, low scaling, 60 °C
Max Maximum temperature setting, 75 °C
Depending upon the system, the actual temperatures may vary
from the set value.
ON/OFF indicator
The ON/OFF indicator illuminates when water is being heated.
4.1
Holiday and absence
f If the appliance is not to be used for a few days, set the tem-
f
perature selector to a position between the frost protection
and energy saving settings.
f If the appliance is not to be used for a longer period, set it to
f
frost protection to conserve energy. If there is no risk of frost
you may disconnect the appliance from the power supply.
f For reasons of hygiene, heat up the content of the water
f
heater once to above 60 °C before initial use.
PSH Trend |
17