Remedy In Case Of Faults; Gasoline Engine; Hydraulic Motor - WAGNER HC 35 G Mode D'emploi

Cleaning the unit (shutting down)
Intake filter in Airless spray gun
Dismounting (fig. 16)
1.
Pull protective guard (1) forward vigorously.
2. Screw grip (2) out of the gun housing. Remove
intake filter (3).
3. Intake filter congested or defective – replace.
Mounting
1. Place intake filter (3) with the long cone into the gun
housing.
2. Screw in grip (2) into the gun housing and tighten.
3. Slot in protective guard (1).

9. Remedy in case of faults

9.1 Gasoline engine

Type of malfunction
Gasoline engine does not
start up

9.2 Hydraulic motor

Type of malfunction
Hydraulic motor stuck
in the lower position.
42
Possible cause
No gasoline
ON/OFF switch to OFF
Gasoline cock closed
Engine problem
Engine defective
Oil level insufficient
Possible cause
Outlet valve seat in the
material feed pump is
loose.
Reversing valve in the
hydraulic motor is stuck
or the upper or lower he-
xagonal nut on the valve
rod has become loose.
g
1
Measures for eliminating the malfunction
Fill the gasoline tank.
Switch the switch to ON
Open the gasoline cock
Please refer to the engine instructions
Bring to the Honda service point
Top up oil
Measure for elimination of malfunction
Ball valve on the material feed pump – lever position
vertical. Screw out sealing screw on hydraulic motor.
Press down reversing valve on hydraulic motor. Remo-
unt sealing screw. Start unit. The piston rod moves
upward and then gets stuck in the lower position. The
cause is a loose outlet valve seat.
Problem to be solved by Wagner personnel.
Problem to be solved by Wagner personnel.
Remedy in case of faults
y
a n
rm
G e
in
d e
M a
2
G 1
x . i
m a p s
0 0
a r
3 9 0 b
2 7
HC 35 G • HC 45 G • HC 55 G
3
2