Installing The Unit; Earthing Of The Object; Cleaning The Unit; Setting-Up On Uneven Surfaces - WAGNER HC 35 G Mode D'emploi

Safety regulations
For reasons of function, safety and durability
i
use only original WAGNER high-pressure
hoses.
b
Electrostatic charging (formation of
sparks or flame)
Under certain circumstances, electrostatic
charging can occur on the unit due to the
rate of flow of the coating material when
spraying. On discharging this can result in
Danger
the emergence of sparks or fire. It is there-
fore necessary that the unit is always earthed through
the electrical installation. The unit must therefore always
be earthed via the carriage frame.
b Installing the unit
Use the Airless spraying unit with a gasoline
engine, preferably outdoors.
Take the wind direction into account. Then
place the unit so that no vapors containing
Danger
solvents are deposited in the area of the unit.
Observe a minimum distance of 3 m between the unit
with gasoline engine and the spray gun.
b Ventilation when spraying in rooms
Adequate ventilation must be guaranteed in order to re-
move the solvent vapors and the exhaust fumes of the
gasoline engine.
b Suctions installations
These are to be set-up by the user of the unit according
to local regulations.
b Earthing of the object
The object to be coated must be earthed.
b Cleaning the unit with solvents
When cleaning the unit with solvents, the
solvent should never be sprayed or pumped
back into a container with a small opening
(bunghole). An explosive gas/air mixture can
Danger
arise. The container must be earthed.
b Cleaning the unit
Danger of short-circuits caused by water
ingressing into the electrical equipment of
the gasoline engine.
Never spray down the unit with high-pres-
Danger
sure or high-pressure steam cleaners.
HC 35 G • HC 45 G • HC 55 G
g
b Setting-up on uneven surfaces
The front side of the unit must point downwards to pre-
vent sliding away.
2.

General view of application

2.1 Application

Priming and final coating of large areas, sealing, impreg-
nation, construction sanitation, façade protection and re-
novation, rust protection and building protection, roof
coating, roof sealing, concrete sanitation, as well as hea-
vy corrosion protection.
Examples of objects to be sprayed
Large-scale construction sites, underground construc-
tion, cooling towers, bridges, sewage treatment plants
and terraces.
Generally for the whole building protection where opera-
tion without electric power is required.

2.2 Coating materials

Processible coating materials
Pay attention to the Airless quality of the
i
coating materials to be processed.
General view of application
31